Link Adaptation Algorithm and Metric for IEEE Standard 802.16
MetadataShow full item record
Broadband wireless access (BWA) is a promising emerging technology. In the past, most BWA systems were based on proprietary implementations. The Institute of Electrical and Electronics Engineers (IEEE) 802.16 task group recently standardized the physical (PHY) and medium-access control (MAC) layers for BWA systems. To operate in a wide range of physical channel conditions, the standard defines a robust and flexible PHY. A wide range of modulation and coding schemes are defined. While the standard provides a framework for implementing link adaptation, it does not define how exactly adaptation algorithms should be developed. This thesis develops a link adaptation algorithm for the IEEE 802.16 standard's WirelessMAN air interface. This algorithm attempts to minimize the end-to-end delay in the system by selecting the optimal PHY burst profile on the air interface. The IEEE 802.16 standard recommends measuring C/(N+I) at the receiver to initiate a change in the burst profile, based on the comparison of the instantaneous the C/(N+I) with preset C/(N+I) thresholds. This research determines the C/(N+I) thresholds for the standard specified channel Type 1. To determine the precise C/(N+I) thresholds, the end-to-end(ETE) delay performance of IEEE 802.16 is studied for different PHY burst profiles at varying signal-to-noise ratio values. Based on these performance results, we demonstrate that link layer ETE delay does not reflect the physical channel condition and is therefore not suitable for use as the criterion for the determination of the C/(N+I) thresholds. The IEEE 802.16 standard specifies that ARQ should not be implemented at the MAC layer. Our results demonstrate that this design decision renders the link layer metrics incapable of use in the link adaptation algorithm. Transmission Control Protocol (TCP) delay is identified as a suitable metric to serve as the link quality indicator. Our results show that buffering and retransmissions at the transport layer cause ETE TCP delay to rise exponentially below certain SNR values. We use TCP delay as the criterion to determine the SNR entry and exit thresholds for each of the PHY burst profiles. We present a simple link adaptation algorithm that attempts to minimize the end-to-end TCP delay based on the measured signal-to-noise ratio (SNR). The effects of Internet latency, TCP's performance enhancement features and network traffic on the adaptation algorithm are also studied. Our results show that delay in the Internet can considerably affect the C/(N+I) thresholds used in the LA algorithm. We also show that the load on the network also impacts the C/(N+I) thresholds significantly. We demonstrate that it is essential to characterize Internet delays and network load correctly, while developing the LA algorithm. We also demonstrate that TCP's performance enhancement features do not have a significant impact on TCP delays over lossy wireless links.
- Masters' Theses