VTechWorks staff will be away for the Thanksgiving holiday beginning at noon on Wednesday, November 27, through Friday, November 29. We will resume normal operations on Monday, December 2. Thank you for your patience.

Browsing by Author "Barringer, Michael David"

Now showing 1 - 2 of 2
  • Thumbnail Image
    Design and Benchmarking of a Combustor Simulator Relevant to Gas Turbine Engines
    Barringer, Michael David (Virginia Tech, 2001-09-20)
    An experimental facility was designed and benchmarked that could simulate the non-uniformities in the flow and thermal fields exiting real gas-turbine combustors. The design of the combustor simulator required analyses of the flow paths within a real combustor in a gas turbine engine. Modifications were made to an existing wind tunnel facility to allow for the installation of the combustor simulator. The overall performance of the simulator was then benchmarked through measurements of velocity, pressure, temperature, and turbulence using a straight exit test section to provide a baseline set of data. Comparisons of the measured quantities were made between two test cases that included a flow field with and without dilution flow.One of the major findings from this study was that the total pressure profiles exiting the combustor simulator in the near-wall region were different from a turbulent boundary layer. This is significant since many studies consider a turbulent boundary layer as the inlet condition to the turbine. Turbulent integral length scales were found to scale well with the dilution hole diameters and no dominant frequencies were observed in the streamwise velocity energy spectra. Dilution flow resulted in an increase in turbulence levels and mixing causing a reduction in the variation of total pressure and velocity. Adiabatic effectiveness levels were significantly reduced for the case with dilution flow in both the near combustor exit region and along the axial length of the straight exit test section.
  • Developing and Testing a Combustor Simulator For Investigating High Pressure Turbine Aerodynamics and Heat Transfer
    Barringer, Michael David (Virginia Tech, 2006-07-20)
    Within a gas turbine engine, the turbine nozzle guide vanes are subjected to very harsh conditions from the highly turbulent and hot gases exiting the combustor. The temperature and pressure fields exiting combustors are highly nonuniform and dictate the heat transfer and aero losses that occur in the turbine passages. To better understand these effects, the goal of this work was to develop an adjustable combustor exit profile simulator for the Turbine Research Facility (TRF) at the Air Force Research Laboratory. The TRF is a high temperature, high pressure, short duration blow-down test facility that is capable of matching several aerodynamic and thermal nondimensional engine parameters including Reynolds number, Mach number, pressure ratio, corrected mass flow, gas to metal temperature ratio, and corrected speed. The primary research objective was to design, install, and verify a non-reacting simulator device that can provide representative combustor exit total pressure and temperature profiles to the inlet of the TRF turbine test section. This required the upstream section of the facility to be redesigned into multiple concentric annuli that serve the purpose of injecting high momentum dilution jets and low momentum film cooling jets into a central annular chamber, similar to a turbine engine combustor. The design of the section allows for variations in injection levels to generate different pressure profiles with elevated turbulence. The dilution and film cooling temperatures can also be varied to create a variety of exit temperature profiles similar to real combustors. The impact of the generated temperature and pressure profiles on turbine heat transfer and secondary flow development was ultimately investigated. Proposed optimal inlet conditions for the turbine tested in this research effort were determined based on the measured data corresponding to the combustor simulator exit profiles that minimized vane heat transfer and total pressure loss.