Browsing by Author "Joyce, Bryan Steven"

Now showing 1 - 2 of 2
  • Thumbnail Image
    Development of Active Artificial Hair Cell Sensors
    Joyce, Bryan Steven (Virginia Tech, 2015-06-04)
    The cochlea is known to exhibit a nonlinear, mechanical amplification which allows the ear to detect faint sounds, improves frequency discrimination, and broadens the range of sound pressure levels that can be detected. In this work, active artificial hair cells (AHC) are proposed and developed which mimic the nonlinear cochlear amplifier. Active AHCs can be used to transduce sound pressures, fluid flow, accelerations, or another form of dynamic input. These nonlinear sensors consist of piezoelectric cantilever beams which utilize various feedback control laws inspired by the living cochlea. A phenomenological control law is first examined which exhibits similar behavior as the living cochlea. Two sets of physiological models are also examined: one set based on outer hair cell somatic motility and the other set inspired by active hair bundle motility. Compared to passive AHCs, simulation and experimental results for active AHCs show an amplified response due to small stimuli, a sharpened resonance peak, and a compressive nonlinearity between response amplitude and input level. These bio-inspired devices could lead to new sensors with lower thresholds of sound or vibration detection, improved frequency sensitivities, and the ability to detect a wider range of input levels. These bio-inspired, active sensors lay the foundation for a new generation of sensors for acoustic, fluid flow, or vibration sensing.
  • Thumbnail Image
    Development of an Electromagnetic Energy Harvester for Monitoring Wind Turbine Blades
    Joyce, Bryan Steven (Virginia Tech, 2011-12-12)
    Wind turbine blades experience tremendous stresses while in operation. Failure of a blade can damage other components or other wind turbines. This research focuses on developing an electromagnetic energy harvester for powering structural health monitoring (SHM) equipment inside a turbine blade. The harvester consists of a magnet inside a tube with coils outside the tube. The changing orientation of the blade causes the magnet to slide along the tube, inducing a voltage in the coils which in turn powers the SHM system. This thesis begins with a brief history of electromagnetic energy harvesting and energy harvesters in rotating environments. Next a model of the harvester is developed encompassing the motion of the magnet, the current in the electrical circuit, and the coupling between the mechanical and electrical domains. The nonlinear coupling factor is derived from Faraday's law of induction and from modeling the magnet as a magnetic dipole moment. Three experiments are performed to validate the model: a free fall test to verify the coupling factor expression, a rotating test to study the model with a load resistor circuit, and a capacitor charging test to examine the model with an energy storage circuit. The validated model is then examined under varying tube lengths and positions, varying coil sizes and positions, and variations in other parameters. Finally a sample harvester is presented that can power an SHM system inside a large scale wind turbine blade spinning up to 20 RPM and can produce up to 14.1 mW at 19 RPM.