Show simple item record

dc.contributor.authorGauden, William H.en
dc.date.accessioned2014-03-14T21:41:22Zen
dc.date.available2014-03-14T21:41:22Zen
dc.date.issued1977-10-15en
dc.identifier.otheretd-07282010-020119en
dc.identifier.urihttp://hdl.handle.net/10919/43934en
dc.description.abstract

The performance and stalling behavior of an axial-flow compressor subjected to several different inlet distortion patterns was investigated. The effect of inlet distortion on overall compressor performance was determined through the measurement of compressor characteristics for each inlet flow condition. Dynamic pressure transducers were employed to investigate rotating stall cell behavior during the inception of stall. Rotor blade response to distorted inflow was measured in the form of average blade pressure profiles by using a scanning valve. Results indicated a substantial reduction in total pressure rise capability for distorted operation. A 25 per cent loss in stall pressure rise was observed for the most severe distortion level. The stall cell was found to rotate in the direction of rotor motion, but at one-half the rotor speed. The cell encompassed the rotor blade tip region down to approximately midspan. During the onset of stall, the circumferential extent of the cell was observed to vary from 60 to 80 degrees. At the rotor blade tip the stall cell relative pressure fluctuations indicated zero flow through the cell. The amplitude of the stall cell was attenuated in the distorted flow region due to the lower air velocity behind the distortion screens. Rotor blade suction side pressure measurements indicated that increasing the circumferential extent of distortion above some "critical" value induced blade stall at higher flow rates. For the low speed compressor used, it appears that the critical angle phenomena is a function of compressor design and is independent of distortion level.

en
dc.format.mediumBTDen
dc.publisherVirginia Techen
dc.relation.haspartLD5655.V855_1977.G39.pdfen
dc.rightsIn Copyrighten
dc.rights.urihttp://rightsstatements.org/vocab/InC/1.0/en
dc.subjectAirplanesen
dc.subject.lccLD5655.V855 1977.G39en
dc.titlePerformance and stalling behavior of an axial-flow compressor subjected to three circumferential inlet distortion levelsen
dc.typeThesisen
dc.contributor.departmentMechanical Engineeringen
dc.description.degreeMaster of Scienceen
thesis.degree.nameMaster of Scienceen
thesis.degree.levelmastersen
thesis.degree.grantorVirginia Polytechnic Institute and State Universityen
thesis.degree.disciplineMechanical Engineeringen
dc.contributor.committeechairO'Brien, Walter F. Jr.en
dc.contributor.committeememberMoses, Hal L.en
dc.contributor.committeememberThomas, William C.en
dc.identifier.sourceurlhttp://scholar.lib.vt.edu/theses/available/etd-07282010-020119/en
dc.date.sdate2010-07-28en
dc.date.rdate2010-07-28en
dc.date.adate2010-07-28en


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record