<p>A brief review of three-dimensional turbulent boundary layer mean velocity profile models was presented, with emphasis on the applicability of these to predict cross flow profiles when skewing existed in any single ...

The bolling film coefficients of sulfur dioxide were obtained from. experiments with an electrically heated wire submerged in a pool of sulfur dioxide liquid. A three-inch 15 Gage Nichrome V wire served as heating element ...

Numerous types of extended surfaces have been used in the past but those with finned pins have proved to be unique in increasing the rate of heat transfer. Hsieh working on the original idea ot professor Hsu proved that ...

It was the intent of this investigation to determine boiling film coefficients of SO₂ in a temperature range not previously investigated. Further, a practical method of circulating liquid SO₂ and reclaiming SO₂ vapor without ...

Extensive investigations employing fins as extended surfaces have been conducted, but relatively little experimental work has been conducted with pins, no information is available on the heat transfer characteristics of a ...

Although many studies have been made on the operating characteristics of instrument bearings, most were conducted at two rpm or less and with thrust load only. A study by H.H. Mable tested the running torques of radially ...

In order to study the degree of accuracy with which the analytical methods used in crankshaft design would predict the actual operating stresses in the crankshaft of an internal combustion engine, electrical resistance ...

The laminar boundary layer over a semi-infinite flat plate which is impulsively set in motion in an incompressible fluid and which has a simultaneous step change in surface temperature was studied. An approximate method ...

<p>This investigation was involved with the combustion of 0.020" diameter aluminum in various mixtures of industrial oxygen and nitrogen at a total pressure of one atmosphere.</p> <p> A combustion chamber was constructed ...

see document