Rosette, Keith Andrew2014-03-142014-03-141994etd-12302008-063020http://hdl.handle.net/10919/46428An array of small, lightweight acoustic sources was investigated to determine how such an arrangement of sources would acoustically interact with a duct similar to that of a turbofan engine inlet. The sources were cylindrically curved aluminum panels excited in vibration by the application of a sinusoidally varying voltage to a piezoceramic actuator bonded to them. The finite element method was used as a design tool to size the panel based on desired vibration characteristics. A boundary element acoustic analysis was used to predict the acoustic output from various arrangements of sources. The central portion of the research was a series of experiments using an array of twelve sources arranged circumferentially in a duct. Measurements of the performance of each source revealed that the performance of the acoustic sources varied from source to source. This variation was assumed to have been caused by differences in the quality of the bond of each of the piezoceramic actuators to the panels. Directivity measurements were made in the far field. Measurements were also taken of the pressure field established in the duct cross-section. Modal decomposition was applied to the data. It was found that the dominant acoustic modes in the duct are those whose cut-on frequencies were near the frequency of excitation.xvi, 193 leavesBTDapplication/pdfenIn CopyrightLD5655.V855 1994.R674Acoustic surface wave devicesAirplanes -- Turbofan engines -- NoiseFans (Machinery) -- NoiseThesishttp://scholar.lib.vt.edu/theses/available/etd-12302008-063020/