Ruda, Mathew Louis2022-06-222022-06-222022-06-22vt_gsexam:35065http://hdl.handle.net/10919/110874This study documents the integration and testing of a new variety of unsteady surface temperature gages designed to operate in high speed flow. Heat flux through the surface of the test article was determined from the unsteady temperature by applying a 3D reconstruction algorithm based on a Green's function approach. The surface temperature gages used in this work were 1.59 mm inserts designed to maximize material matching with the test article, in this case 316 stainless steel. A series of benchtop experiments were first performed to understand the individual properties of the gage and determine measurement uncertainty. Prior to testing, all temperature gages are calibrated using an environmental chamber. Gages were installed into slugs of several materials and subjected to a heated jet with a total temperature of 620 K to examine the effects of material mismatch. A shock tube with a notional operating Mach of 2.6 was used to determine the thermal response of the gages as a function of time. In both tests, reference Medtherm Schmidt-Boelter gages ensure consistent heat fluxes are applied across all runs. The time response of the entire electrical system was determined by subjecting the gage to a nanosecond scale laser pulse. Two experimental campaigns were conducted in Virginia Tech's Hypersonic Wind Tunnel. First, gages were integrated into a flat plate test article and subjected to a notionally 2D Mach 3 flow. Tunnel total pressures and temperatures ranged from 793-876 kPa and 493-594 K, respectively. A reference 3.18 mm Medtherm Schmidt-Boelter gage was also installed for comparison. All temperature data are reconstructed using the algorithm to determine heat flux. The second test campaign utilized a flat-faced cylindrical test article in a notionally axisymmetric Mach 6 flow environment. Flow total pressures and temperatures ranged from 8375-8928 kPa and 485.5-622 K. respectively. The Fay-Riddell analytical method was applied to the resulting temperature traces in order to infer the heat flux at the stagnation point for comparison with the reconstructed heat flux. This experiment was complimented with steady, 3D CFD in order to understand the temperature variation across the test article. Both campaigns demonstrate good agreement between the heat flux reconstructed from surface temperatures measured using the new gage, reference measurements, and simulations/analytical methods. The importance of material matching is highlighted during this study. The performance of this gage is shown to exceed the current state-of-the-art, opening the possibility for future analysis of phenomenon present in high-speed flow.ETDenIn Copyrightheat fluxhypersonicthermal instrumentationheat transferDissertation