University of VirginiaNational Renewable Energy Laboratory (U.S.)Virginia Tech. Aerospace and Ocean Engineering DepartmentQin, ChaoLoth, EricLee, SangMoriarty, Patrick2015-07-282015-07-282015-06Qin, C., Loth, E., Lee, S., & Moriarty, P. (2015, June). Investigation of dynamic loading for 13.2 mw downwind pre-aligned rotor. Paper presented at the North American Wind Energy Academy 2015 Symposium, Blacksburg, VA.http://hdl.handle.net/10919/54674To alleviate the mass-scaling issues associated with conventional upwind rotors of extreme-scale turbines, a downwind rotor concept is considered that uses fixed coning to align the non-circumferential loads for a given steady-state condition. This alignment can be pre-set to eliminate downwind blade moments for a given steady-state condition at rated wind speed and to minimize them for other conditions. The alleviation in downwind dynamic loads may enable a reduced structural blade mass as compared with a conventional upwind rotor. To examine the potential impact of this design, FAST simulations were conducted for a 13.2 MW rated turbine at steady-state conditions for two rotor configurations with similar power outputs: 1) a conventional upwind rotor with three blades and 2) a downwind pre-aligned rotor with two blades. The rotor mass was reduced by approximately 25% for the downwind pre-aligned configuration. In addition, the damage equivalent loads on the blades were reduced more than 60% for the downwind pre-aligned configuration. However, additional work is needed to investigate this concept at turbulent inflow conditions and for extreme events.22 pagesapplication/vnd.ms-powerpointapplication/pdfen-USIn CopyrightPresentationQin, ChaoLoth, EricLee, SangMoriarty, Patrick