Defreitas, Aaron Chad2023-04-212023-04-212021-10-27vt_gsexam:32721http://hdl.handle.net/10919/114734Wind tunnel experiments often employ a wide variety and large number of sensor systems. Anomalous measurements occurring without the knowledge of the researcher can be devastating to the success of costly experiments; therefore, anomaly detection is of great interest to the wind tunnel community. Currently, anomaly detection in wind tunnel data is a manual procedure. A researcher will analyze the quality of measurements, such as monitoring for pressure measurements outside of an expected range or additional variability in a time averaged quantity. More commonly, the raw data must be fully processed to obtain near-final results during the experiment for an effective review. Rapid anomaly detection methods are desired to ensure the quality of a measurement and reduce the load on the researcher. While there are many effective methodologies for anomaly detection used throughout the wider engineering research community, they have not been demonstrated in wind tunnel experiments. Wind tunnel experimentation is unique in the sense that many repeat measurements are not typical. Typically, this will only occur if an anomaly has been identified. Since most anomaly detection methodologies rely on well-resolved knowledge of a measurement to uncover the expected uncertainties, they can be difficult to apply in the wind tunnel setting. First, the analysis will focus on pressure measurements around an airfoil and its wake. Principal component analysis (PCA) will be used to build a measurement expectation by linear estimation. A covariance matrix will be constructed from experimental data to be used in the PCA-scheme. This covariance matrix represents both the strong deterministic relations dependent on experimental configuration as well as random uncertainty. Through principles of ideal flow, a method to normalize geometrical changes to improve measurement expectations will be demonstrated. Measurements from a microphone array, another common system employed in aeroacoustic wind tunnels, will be analyzed similarly through evaluation of the cross-spectral matrix of microphone data, with minimal repeat measurements. A spectral projection method will be proposed that identifies unexpected acoustic source distributions. Analysis of good and anomalous measurements show this methodology is effective. Finally, machine learning technique will be investigated for an experimental situation where repeat measurements of a known event are readily available. A convolutional neural network for feature detection will be shown in the context of audio detection. This dissertation presents techniques for anomaly detection in sensor systems commonly used in wind tunnel experiments. The presented work suggests that these anomaly identification techniques can be easily introduced into aeroacoustic experiment methodology, minimizing tunnel down time, and reducing cost.ETDIn Copyrightwind tunnelanomaly detectioneigendecompositionDissertation