Browsing by Author "Ninnemann, Todd A."
Now showing 1 - 2 of 2
Results Per Page
Sort Options
- Aspirating probes for measurement of mean concentration and fluctuating quantities in supersonic air/helium shear layerNinnemann, Todd A. (Virginia Tech, 1990-12-31)Two aspirating hot-film probes are developed to make measurements in supersonic air/helium shear layers. The first probe is designed to measure local mean gas composition and is referred to as the mean concentration probe. This probe consists of a constant temperature hot-film sensor operating in a channel with a choked exit. The flow over the hot-fifm is influenced only by total temperature, total pressure, and gas composition. The mean probe is easily calibrated and shows acceptable sensitivity to flow angularity. The second probe is based on an improved design of the mean concentration probe. In addition to measuring mean composition, this second probe also measures turbulence intensities of Reynolds number and thermal conductivity using a multiple overheat method. This probe is referred to as the turbulent probe. Both probes are used in the study of supersonic air/helium mixing layers in the VPI&SU 23 cmx23 cm Supersonic Wind Tunnel. Profiles of mean and turbulent quantities are presented.
- Effects of riblets on the performance of the supersonic through-flow fan cascade bladesNinnemann, Todd A. (Virginia Tech, 1994-09-01)An experimental study to determine the effects of riblets on the performance of the supersonic through-flow fan (STF) cascade blades was performed. The two-dimensional cascade was tested in the Virginia Polytechnic Institute and State University intermittent wind tunnel facility, where the Mach and Reynolds (based on chord) numbers were 2.36 and 4.8 x 10⁶ , respectively. Three different V-grooved riblet heights were tested on the blades: 0.023, 0.033, and 0.051 mm. Riblet testing were conducted at design incidence as well as at off-design conditions (incidence angles: +5, -10 deg). The riblet effect on the performance of the STF blades was determined by measuring the total pressure profile downstream of the cascade and integrating this total pressure to obtain an overall mass-averaged loss coefficient. The riblet loss coefficient was compared with the loss coefficient of a control test case where an equivalent thickness of smooth material is applied to the blades. Results show that, at the design incidence, the 0.033 mm height riblets provided the optimal benefit, with a reduction of 8.5% in the loss coefficient compared to the control case. Smaller effects were measured at the off-design conditions. Shadowgraph pictures were taken to study the effect of riblets on the turbulent transition location on the blades surfaces. At design incidence, the shadowgraphs revealed that the optimum height rib lets delayed the transition location on the suction surface of the blades. Therefore, it was concluded that for the 0.033 mm height riblets the decrease in the cascade's loss coefficient was the result of delayed transition in addition to a decrease in turbulent viscous losses. A numerical simulation was conducted to investigate both rib let effects on the STF blades. The numerical study showed that only the combination of the two riblet effects was able to produce a decrease in loss coefficient that was observed experimentally. Results from the numerical study indicate, that at design incidence, 2/3 of the rib let benefit is attributed to the delayed transition effect on the blades with the other 1/3 resulting from a decrease in turbulent viscous losses.