School of Plant and Environmental Sciences
Permanent URI for this community
SPES was formed in 2017 from three departments: Crop and Soil Environmental Sciences; Horticulture; and Plant Pathology, Physiology, and Weed Science.
Browse
Browsing School of Plant and Environmental Sciences by Subject "07 Agricultural and Veterinary Sciences"
Now showing 1 - 4 of 4
Results Per Page
Sort Options
- Counterions, smectite, and palygorskite increase microstructural stability of saline-sodic soilsJavaheri, F.; Esfandiarpour-Boroujeni, Isa; Farpoor, Mohammad Hady; Holthusen, D.; Stewart, Ryan D. (Elsevier, 2022-02-01)Saline-sodic soils are susceptible to wind and water erosion when the dispersive effect of sodium overcomes inter-particle bonds. Rheological parameters of viscoelasticity can help to quantify inter-particle attractive forces and account for the effect of salinity in these soils. The main objective of the present study was to investigate the viscoelasticity behavior of saline-sodic soils of the Sirjan playa in south-central Iran. Three representative pedons were excavated and described by horizon. Soil physicochemical properties and rheological properties were determined, namely the micromechanical parameters flow point (γf), loss factor tan δ, and integral z, with samples analyzed at three matric potentials (0, −6, and −15 kPa). Results showed that soil microstructural stiffness was mainly influenced by soil texture, clay minerals, gypsum, calcium carbonate equivalent (CCE), and matric potential. The dispersive effect of sodium, as indicated by low integral z and γf values, decreased with increasing gypsum content in − 6 and − 15 kPa matric potentials (0.6 < r < 0.8) and CCE percentage in the quasi-saturated (0 kPa) condition (r > 0.8). However, greater microstructural stability (i.e., higher integral z and γf) was observed for fine-textured soils with relatively high amounts of smectite and palygorskite and low pH. Furthermore, integral z and γf increased with lower matric potentials due to the stabilizing effect of menisci forces. Therefore, the viscoelastic behavior of the saline-sodic soils was negatively associated with water content and high sodium concentration, while the presence of smectite, palygorskite, gypsum, and CCE improved the soil physical conditions and thus the rigidity of the porous system. These results demonstrate that rheological measurements can identify saline-sodic soils that have strongly degraded microstructural stability and would most benefit from active management and amelioration.
- Evaluating rare earth elements as tracers of fluvial processes: Fine sediment transport and deposition in a small streamGovenor, Heather; Hession, W. Cully; Keys, Tyler A.; Jones, C. Nathan; Stewart, Ryan D.; Krometis, Leigh-Anne H. (ASABE, 2021-01-01)Effective sediment management requires an understanding of the lag time between best management practice implementation and observable changes in the target water body. To improve our understanding of sediment lag times, we tested a method to label locally sourced sediments with rare earth elements to quantify fine sediment flow-through and storage in fluvial systems. We injected sediments labeled with lanthanum and ytterbium into a small stream during two artificial flood events. During the floods, we collected and quantified suspended sediments and sediment deposition in the stream channel and floodplain at four cross-sections within our study reach. Two down-gradient (90 m and 850 m) timeintegrated suspended sediment samplers evaluated total travel distance. Sediment tracer observations of particle transport distances ranged from 0 m to at least 850 m at a maximum flow rate of 55 L s-1 (stream 1.5 year flow was 515 L s-1). Sediment deposition per unit area was greater in the channel than in the floodplain. The majority of sediment tracer mass injected into the stream entered storage within the first 69 m of the reach. Some particles that deposited following the first flood were resuspended and either transported downstream or redeposited within the study reach. Our results support the further use of rare earth elements as sediment tracers to inform water quality and sediment transport models, and to provide estimates of lag times between management actions and downstream improvements.
- Measuring shrinkage of undisturbed soil pedsShockey, Matthew C.; Stewart, Ryan D.; Keim, Richard F. (Wiley, 2021-10-19)Methods to measure shrinkage curves typically either disturb natural aggregate structure or include difficult or slow volume measurement techniques. Additionally, most shrinkage curves are obtained by serial measurement of a few samples. We obtained shrinkage curves by collecting rapid, one-off measurements of volume and moisture content for each of 200 undisturbed peds extracted from a field soil, taking measurements as peds slowly dried in the laboratory. The large sample size increased robustness of the shrinkage curve parameter estimates to noise generated by this rapid measurement technique, but a much smaller sample would have resulted in similar parameter estimates.
- Rheological evaluation of soil aggregate microstructure and stability across a forested catenaJavaheri, Fatemeh; Esfandiarpour-Boroujeni, Isa; Kourki, Hajir; Farpoor, Mohammad Hady; Stewart, Ryan D. (Elsevier, 2021-12-01)Rheological characteristics of soils, including their deformation and flow behaviors when subjected to external stress, can provide important information on microstructural stability. In this study we used rheological measurements to examine the soil aggregate microstructure and stability of four different soil orders – Alfisol, Mollisol, Inceptisol, and Entisol – along a forested catena in Mazandaran Province, northern Iran. Amplitude sweep tests were used to quantify the initial values of the storage and loss moduli, deformation limit (when the material begins to transition from reversible to irreversible deformation), deformation at flow point (when the material becomes viscous), and integral z (which summarizes the overall visco-elasticity of the material). The deformation limit was significantly higher in subsoil layers than topsoil layers, and was also higher in the Mollisol than the other pedons. The flow point and integral z values, which relate to the structural stiffness of soil matrices, were largest in the Btg horizons of the Alfisol and Mollisol, implying that these soils had more rigid microstructures. In contrast, the Entisol Ckg horizon, which had high sand content and little soil development, had the lowest values for all properties, thus indicating a lack of micro-aggregate stability. Regression analyses revealed that integral z was influenced by soil physicochemical properties, and was higher in soils whose clay fraction was dominated by expansive clay minerals and pedogenic iron and aluminum sesquioxides. Altogether, the rheological parameters indicated that older, more developed soils had greater microstructural stability than their less developed counterparts. As a result, rheological measurements may be useful for identifying the major factors that affect soil aggregation, and can indicate the relative amount of soil development along gradients such as the studied forest catena.