This dissertation presents the results of a study performed to investigate methods for increasing the damping capacity of concrete. A variety of additives, both particle and latex based, were added to standard concrete mixtures by replacing up to 20% of the fine aggregate to measure their effects on strength, stiffness, damping, and air content. The additives included rubber particles from recycled tires, calcium carbonate particles, styrene butadiene rubber (SBR) latex, and a commercially available product named ConcreDamp which contains vegetable gum suspended in styrene butadiene latex.

An initial investigation resulted in the observation that all of the additives with the exception of the SBR latex would both increase air content and decrease compressive strength. As a result, combinations of additives were investigated to see if both the mechanical and dynamic properties could be improved. The addition of steel fibers to mixtures with ground rubber were found to significantly increase air content which offset any gains in compressive strength. The combination of ground rubber and latex was shown to improve both increase compressive strength and reduce air content.

The study advanced to investigate the effects of rubber size on air content, strength, and damping. It was found that for the same volume of rubber, a larger rubber particle would decrease air content, decrease compressive strength, and improve damping.

The results of this study show that the best performing additive was the vegetable gum latex which improved the concrete damping by a factor of 2 when added as 15% of the fine aggregate. Additionally, an equation is presented for calculating a strength reduction factor for concrete containing rubber particles of different sizes.

Finally, two full scale footbridge laboratory specimens were tested to investigate the effect of increased material damping at the structural level. One footbridge was constructed using a base concrete mixture without damping admixtures. The second was constructed with a concrete mixture that contained a replacement of 15% of the fine aggregate with ground rubber. The results were used to create a finite element model in SAP2000 that was used to predict the effects that high damping concretes would have on the footbridge specimen.