Development and Deployment of Renewable and Sustainable Energy Technologies
Jung, Jae Sung
MetadataShow full item record
Solar and wind generation are one of the most rapidly growing renewable energy sources, and is regarded as an appealing alternative to conventional power generated from fossil fuel. This is leading to significant levels of distributed renewable generation being installed on distribution circuits. Although renewable generation brings many advantages, circuit problems are created due to its intermittency, and overcoming these problems is a key challenge to achieving high penetration. It is necessary for utilities to understand the impacts of Photovoltaic (PV) generation on distribution circuits and operations. An impact study is intended to quantify the extent of the issues, discover any problems, and investigate alternative solutions. In this manner, system wide and local impact study are proposed in the dissertation. 1) System wide impact study This study considers system effects due to the addition of Plug-in Hybrid Vehicles (PHEV) and Distributed Energy Resource (DER) generation. The DER and PHEV are considered with energy storage technology applied to the residential distribution system load. Two future year scenarios are considered, 2020 and 2030. The models used are of real distribution circuits located near Detroit, Michigan, and every customer load on the circuit and type of customer are modeled. Monte Carlo simulations are used to randomly select customers that receive PHEV, DER, and/or storage systems. The Monte Carlo simulations provide not only the expected average result, but also its uncertainty. 2) Local impact study Analysis of high PV penetration in distribution circuits using both steady-state and quasi steady-state impact studies are presented. The steady-state analysis evaluates impacts on the distribution circuit by comparing conditions before and after extreme changes in PV generation at three extreme circuit conditions, maximum load, maximum PV generation, and when the difference between the PV generation and the circuit load is a maximum. The quasi steady-state study consists of a series of steady-state impact studies performed at evenly spaced time points for evaluating the spectrum of impacts between the extreme impacts. Results addressing the impacts of cloud cover and various power factor control strategies are presented. PV penetration levels are limited and depend upon PV generation control strategies and the circuit design and loading. There are tradeoffs in PV generation control concerning circuit voltage variations, circuit losses, and the motion of automated utility control devices. The steady state and quasi steady-state impact studies provide information that is helpful in evaluating the effect of PV generation on distribution circuits, including circuit problems that result from the PV generation. In order to fully benefit from wind power, accurate wind power forecasting is an essential tool in addressing this challenge. This has motivated researchers to develop better forecast of the wind resources and the resulting power. As a solution for wind generation, frequency domain approach is proposed to characterize and analyze wind speed patterns in the dissertation. 3) Frequency Domain Approach This study introduces the frequency domain approach to characterize and analyze wind speed patterns. It first presents the technique of and the prerequisite conditions for the frequency domain approach. Three years of wind speed data at 10 different locations have been used. This chapter demonstrates that wind speed patterns during different times and at different locations can be well characterized by using the frequency domain approach with its compact and structured format. We also perform analysis using the characterized dataset. It affirms that the frequency domain approach is a useful indicator for understanding the characteristics of wind speed patterns and can express the information with superior accuracy. Among the various technical challenges under high PV penetration, voltage rise problems caused by reverse power flows are one of the foremost concerns. The voltage rises due to the PV generation. Furthermore, the need to limit the voltage rise problem limits PV generators from injecting more active power into the distribution network. This can be one of the obstacles to high penetration of PVs into circuits. As a solution for solar generation, coordinated control of automated devices and PV is proposed in the dissertation. 4) Coordinated Automated Device and PV Control A coordinating, model-centric control strategy for mitigating voltage rise problems due to PV penetration into power distribution circuits is presented. The coordinating control objective is to maintain an optimum circuit voltage distribution and voltage schedule, where the optimum circuit operation is determined without PV generation on the circuit. In determining the optimum circuit voltage distribution and voltage schedule, the control strategy schedules utility controls, such as switched capacitor banks and voltage regulators, separate from PV inverter controls. Optimization addresses minimizing circuit losses and motion of utility controls. The coordinating control action provides control setpoints to the PV inverters that are a function of the circuit loading or time-of-day and also the location of the PV inverter. Three PV penetration scenarios are considered, 10%, 20%, and 30%. Baselines with and without coordinating controls for circuit performance without PV generation are established, and these baselines are compared against the three PV penetration scenarios with and without coordinating control. Simulation results are compared and differences in voltage variations and circuit losses are considered along with differences in utility control motion. Results show that the coordinating control can solve the voltage rise problem while minimizing circuit losses and reducing utility control motion. The coordinating control will work with existing PV inverter controls that accept control setpoints without having to modify the inverter controls. 5) Coordinated Local and Centralized PV Control Existing distribution systems and their associated controls have been around for decades. Most distribution circuits have capacity to accommodate some level of PV generation, but the question is how much can they handle without creating problems. It proposes a Configurable, Hierarchical, Model-based, Scheduling Control (CHMSC) of automated utility control devices and photovoltaic (PV) generators. In the study here the automated control devices are assumed to be owned by the utility and the PV generators and PV generator controls by another party. The CHMSC, which exists in a hierarchical control architecture that is failure tolerant, strives to maintain the voltage level that existed before introducing the PV into the circuit while minimizing the circuit loss and reducing the motion of the automated control devices. This is accomplished using prioritized objectives. The CHMSC sends control signals to the local controllers of the automated control devices and PV controllers. To evaluate the performance of the CHMSC, increasing PV levels of adoption are analyzed in a model of an actual circuit that has significant existing PV penetration and automated voltage control devices. The CHMSC control performance is compared with that of existing, local control. Simulation results presented demonstrate that the CHMSC algorithm results in better voltage control, lower losses, and reduced automated control device motion, especially as the penetration level of PV increases.
- Doctoral Dissertations