Optimum First Failure Loads of Sandwich Plates/Shells and Vibrations of Incompressible Material Plates

Abstract

Due to high specific strength and stiffness as well as outstanding energy-absorption characteristics, sandwich structures are extensively used in aircraft, aerospace, automobile, and marine industries. With the objective of finding lightweight blast-resistant sandwich structures for protecting infrastructure, we have found, for a fixed areal mass density, one- or two-core doubly-curved sandwich shell's (plate's) geometries and materials and fiber angles of unidirectional fiber-reinforced face sheets for it to have the maximum first failure load under quasistatic (blast) loads. The analyses employ a third-order shear and normal deformable plate/shell theory (TSNDT), the finite element method (FEM), a stress recovery scheme (SRS), the Tsai-Wu failure criterion and the Nest-Site selection (NeSS) optimization algorithm, and assume the materials to be linearly elastic. For a sandwich shell under the spatially varying static pressure on the top surface, the optimal non-symmetric one-core (two-core) design improves the first failure load by approximately 33% (27%) and 50% (36%) from the corresponding optimal symmetric design with clamped and simply-supported edges, respectively. For a sandwich plate under blast loads, it is found that the optimal one-core design is symmetric about the mid-surface with thick face sheets, and the optimal two-core design has a thin middle face sheet and thick top and bottom face sheets. Furthermore, the transverse shear stresses (in-plane transverse axial stresses) primarily cause the first failure in a core (face sheet). For the computed optimal design under a blast load, we also determined the collapse load by using the progressive failure analysis that degrades all elasticities of the failed material point to very small values. The collapse load of the clamped (simply-supported) sandwich structure is approximately 15%–30% (0%–17%) higher than its first failure load. Incompressible materials such as rubbers, polymers, and soft tissues that can only undergo volume preserving deformations have numerous applications in engineering and biomedical fields. Their vibration characteristics are important for using them as wave reflectors at interfaces with a fiber-reinforced sheet. In this work we have numerically analyzed free vibrations of plates made of a linearly elastic incompressible rubber-like material (Poison's ratio = 0.5) by using a TSNDT for incompressible materials and the mixed FEM. The displacements at nodes of a 9-noded quadrilateral element and the hydrostatic pressure at four interior nodes are taken as unknowns. Computed results are found to match well with the corresponding either analytical or numerical ones obtained with the commercial FE software Abaqus and the 3-dimensional linear elasticity theory. The analysis discerns plate's in-plane vibration modes. It is found that a simply supported plate admits more in-plane modes than the corresponding clamped and clamped-free plates.