Lamb wave propagation in laminated composite plates

Low frequency Lamb waves in composite laminates were investigated theoretically and experimentally. To have a general solution for Lamb wave propagation in multilayered composite laminates is not practical due to a large number of boundary conditions needed to be satisfied at the interlaminar interfaces. Various approximate theories have been proposed to model low frequency Lamb wave propagation in composite laminates. In the present study, an approximate solution was derived from an elementary shear deformation plate theory and was shown to work well in the low frequency, long wavelength region.

A simple method, similar in configuration to the acousto-ultrasonic technique, was used to measure Lamb wave phase velocities. Low frequency Lamb waves, usually in the range of 10 kHz to 1 MHz, were generated. Dispersion curves of the lowest symmetric Lamb mode and the lowest antisymmetric Lamb mode were obtained. The experimental data were compared with the results obtained from the approximate solution for the lowest Lamb modes in the low frequency, long wavelength region for a unidirectional laminate, a symmetric cross-ply laminate, a symmetric quasi-isotropic laminate and an aluminum plate. There is good correlation between the data and the results obtained from the approximate solution, which suggests that the lowest Lamb modes are modeled adequately by the present theory in these cases. This experimental procedure of measuring phase velocities can be used to characterize laminated composite plates with and without damage since each material and stacking sequence gives distinct lowest symmetric and antisymmetric curves.

Stiffness reduction of composite laminates caused by damage can be related to the change in Lamb wave propagation speed. Damage in the form of transverse cracks in the 90° plies of a [90/90/90/0], graphite/epoxy laminate reduced the phase velocities of the Lamb modes. The lowest antisymmetric mode is sensitive to stiffness reduction in composite plates. Consequently, axial stiffness reduction in [0/45/0/45/0/45], and [0]₁₂ woven graphite/polyimide composite laminates was monitored by the lowest antisymmetric Lamb mode.