Vibration Reduction and Energy Harvesting using Motion-Rectified Tuned Mass-Damper-Inerters in Semi-Submersible Offshore Wind Platforms

As a result of global warming, the prevalence of renewable energy sources such as wind farms has steadily increased over the last few decades. The wind industry is experiencing a push towards the offshore market, where wind speeds are higher and steadier, and wind farms can be co-located with areas of high populations, such as along the US East Coast. However, high wind and wave loading is proving costly for offshore developments, particularly floating structures such as semi-submersibles. Vibrations in the pitch and heave directions associated with greater yaw-bearing and tower-base bending moments, respectively, reduce the lifespan of these structures. This paper compares traditional tuned-mass dampers (TMDs) and tuned-mass damper inerters (TMDIs) with a nonlinear TMDI which utilizes a mechanical motion rectifier (MMR) to translate bidirectional to unidirectional motion of the primary generator shaft. The integration of the MMR system also permits the generator to disconnect from the tuned-mass damper inerter system when the generator is already spinning at a higher rate, thus providing potential to harvest additional energy from the vibration absorber. However, results show that the optimal nonlinear tuned-mass damper inerters results in near total engagement, reducing the efficacy of the system if optimal parameters can be feasibly sourced. The technology does show promise for situations where these optimal parameters cannot be attained, such as due to high stroke lengths and extremely low stiffnesses to correspond to the low platform frequencies. The development and preliminary testing of a 1/50th scale tuned-mass damper inerter prototype will be discussed; however, the full MMR system has yet to be integrated into the prototype.