Airborne Nanoparticles: Generation, Characterization, and Occupational Exposure

Simple item page
dc.contributor.authorYeganeh Talab, Behnoushen
dc.contributor.committeechairMarr, Linsey C.en
dc.contributor.committeememberVikesland, Peter J.en
dc.contributor.committeememberLove, Nancy G.en
dc.contributor.departmentEnvironmental Engineeringen
dc.date.accessioned2014-03-14T21:32:08Zen
dc.date.adate2007-03-26en
dc.date.available2014-03-14T21:32:08Zen
dc.date.issued2007-03-14en
dc.date.rdate2007-03-26en
dc.date.sdate2007-03-20en
dc.description.abstractDespite the rapid growth in nanotechnology, very little is known about the unintended health or environmental effects of manufactured nanomaterials. The development of nanotechnology risk assessments and regulations requires quantitative information on the potential for exposure to nanomaterials. In addition, to facilitate life-cycle assessments and inhalation toxicology studies, robust methods are needed to generate aerosolized engineered nanoparticles. We conducted a set of field studies to measure the fine particle mass concentrations (PM2.5) as well as nanoparticle number concentrations and size distributions in two nanomaterial manufacturing facilities. Measurements were performed near the reactor, in the breathing zone, and at a background site. Increases in PM2.5 and particle number concentrations were associated with physical handling of nanomaterials. The highest PM2.5 concentration observed was 2700 ug m-3 during sweeping of the reactor in the commercial plant. In most cases, an increase in the number of sub-100 nm particles accounted for the increase in total number concentrations. The results of this research can be used to develop guidelines for workplace regulations to minimize workers' exposure to nanoparticles. Furthermore, we used an atomizer to aerosolize C60 aggregates from a fullerene-water suspension. Measurement of particle size distributions and number concentrations showed that increasing the initial fullerene concentration resulted in increased number of aerosolized particles, while the average size of particles remained relatively constant. To return the aerosolized fullerenes into water, we passed the aerosol sample through an impinger. Reducing the flow rate through the impinger resulted in an increase in the collection efficiency of airborne nanoparticles.en
dc.description.degreeMaster of Scienceen
dc.identifier.otheretd-03202007-124201en
dc.identifier.sourceurlhttp://scholar.lib.vt.edu/theses/available/etd-03202007-124201/en
dc.identifier.urihttp://hdl.handle.net/10919/41734en
dc.publisherVirginia Techen
dc.relation.haspartBehnoushYeganeh-MS2007.pdfen
dc.rightsIn Copyrighten
dc.rights.urihttp://rightsstatements.org/vocab/InC/1.0/en
dc.subjectworkplace exposureen
dc.subjectparticle controlen
dc.subjectnanoparticlesen
dc.subjectnanomaterialsen
dc.subjectC60 fullereneen
dc.subjectoccupational healthen
dc.titleAirborne Nanoparticles: Generation, Characterization, and Occupational Exposureen
dc.typeThesisen
thesis.degree.disciplineEnvironmental Planningen
thesis.degree.grantorVirginia Polytechnic Institute and State Universityen
thesis.degree.levelmastersen
thesis.degree.nameMaster of Scienceen

Files

Original bundle
Now showing 1 - 1 of 1
Thumbnail Image
Name:
BehnoushYeganeh-MS2007.pdf
Size:
870 KB
Format:
Adobe Portable Document Format
Download

Collections

Masters Theses